The Hot Shot Pipe Thawer works best on a single run of metal pipe used for water supply. The pressure behind the frozen section of pipe with an open faucet at the other end greatly increases the speed of thawing. (See picture above)
The thawing speed refers to the amount of time it takes to thaw the film of water against the wall of the pipe, the water pressure will take over from there and melt the rest of the ice.

Click here for instructions regarding Hot Water Heating systems.


***THINGS TO REMEMBER***
DO - make sure there is water pressure at one side of the frozen section.
DO - open faucets so moving water can help thaw the pipes.
DO - disconnect all electrical grounds attached to the thawing area.
DO - disconnect other appliances while using the Hot Shot 320.
DO - use only heavy-duty extension cords.
DO - unwind the cables
DO - clean the pipe to ensure a good connection.
DO - connect clamps to the pipe on either side of the frozen section.
DO - make all connections to the pipe before plugging in the Hot Shot 320.
DO - watch for overheating and possible fires.

DO NOT - leave cables wound up
DO NOT - make quick connections to a dirty pipe.
DO NOT - move the clamps while a current is flowing.
DO NOT - leave the Hot Shot 320 unattended.
DO NOT - leave the Hot Shot 320 switched "ON" overnight.